- Need Help!- Candle Grblcontrol Spindle RPM only changing manually
-
Member
Candle Grblcontrol Spindle RPM only changing manually
Hello,
I am working with a Genmitsu ProverXL 4030 and Candle. I had noticed that the spindle RPM is only controlled by the physical control board (not on Candle) even when I run Gcode with a set RPM. I can set an RPM on canlde, but the spindle ignores that values and only follows the control board. How can I get the spindle RPM to match the RPM that I set in my code or Candle?
Similar Threads:
-
- Need Help!- Candle Grblcontrol Spindle RPM only changing manually
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules