Tree VMC 750 (Green Button does not work) please help


Results 1 to 3 of 3

Thread: Tree VMC 750 (Green Button does not work) please help

  1. #1
    Member GaryRenalds's Avatar
    Join Date
    Aug 2021
    Posts
    4
    Downloads
    0
    Uploads
    0

    Default Tree VMC 750 (Green Button does not work) please help

    Hey there.
    I’ve got a Tree VMC 750 w/ Acramatic controller.

    I’ve got So I’m having 2 problems:
    1) I was trying to align, the table went to the corner, but the Y axis kept overtraveling and error-ing out. Couldn’t get it aligned. I put in a new proximity sensor maybe 4 months ago, for the Y axis, cause it went out and wasn’t reading. It’s been working perfectly until now.

    This was new, so I assumed it was something small. Cleared out the chips from the back wall. Reset it. Slowed down the feed. Tried again. Tried again a couple times, til controller stopped responding. So I turned off the machine, to be try a hard reset, which brings me to problem #2

    2) When I turned the machine back on, it loaded up, but it wouldn’t “start” with the green button as it normally does. So it’s stuck not able to do anything. Air pressure is good.

    I’m assuming this is because axis are over limit on start?

    Does anyone know how to manually move the axis? I’m looking around the machine and I can’t find any “doors” as I’ve read in other posts. Maybe I’m not seeing something.

    Thank you in advance for any help!

    Similar Threads:


  2. #2
    Member
    Join Date
    Oct 2006
    Location
    USA
    Posts
    60
    Downloads
    0
    Uploads
    0

    Default Re: Tree VMC 750 (Green Button does not work) please help

    There should be a key switch for “deblock limit switch” I think on the side of the electrical cabinet. Turn the switch, press data reset, then press start. You should be able to jog off switch. Some machine you need to hold the green button or the cntl button to jog. It should stop once you’re off the switch, then turn the key and off you go.

    Bob@ZPS



  3. #3
    Member
    Join Date
    Oct 2006
    Location
    USA
    Posts
    60
    Downloads
    0
    Uploads
    0

    Default Re: Tree VMC 750 (Green Button does not work) please help

    Oh… also… clean the chips out of the two grey troughs with covers on the back of the machine.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Tree VMC 750 (Green Button does not work) please help

Tree VMC 750 (Green Button does not work) please help