Need Help! Magazine Position Problem on Tree VMC-800


Results 1 to 2 of 2

Thread: Magazine Position Problem on Tree VMC-800

  1. #1
    Member CPPC's Avatar
    Join Date
    Jun 2020
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Magazine Position Problem on Tree VMC-800

    We have a VMC-800 Tree Mill with TPC-2100 Control System. We have faced a problem with tool changer that we could not figure it out. The magazine advance 1 step more that what it is supposed to go to. For instance if it is supposed to go to tool number 2, it goes to tool No. 3 and then the control system stops the machine as it recognizes that the tool changer is not in the correct position. So the control recognizes the fault but any time we reset, we will have the exact same problem, I do appreciate if anyone could help us to rectify this.

    Similar Threads:


  2. #2
    Member
    Join Date
    Mar 2010
    Location
    USA
    Posts
    45
    Downloads
    0
    Uploads
    0

    Default Re: Magazine Position Problem on Tree VMC-800

    sorry hadn't been on in while to respond and just saw this... I have same control on a VMC-750 Tree, not a ZPS machine. Anyway does it cycle through the Tool alignement OK on startup?



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Magazine Position Problem on Tree VMC-800

Magazine Position Problem on Tree VMC-800

Magazine Position Problem on Tree VMC-800