- Need Help!- Journeyman 325 Tree Mill
-
Member
Journeyman 325 Tree Mill
Our Journeyman 325 with allen bradley 9 control intermittently drops the tool during machining cycle
we do not know if we have type 1 2 or 3 spindel
Similar Threads:
-
-
Member
Re: Journeyman 325 Tree Mill
Look up in the taper. Rev 3 has collet with 6 balls and 6mm Allen screw in middle. Rev 2 has a collet with 3 balls and a knock-out button in center past the taper. Rev 1 has 6 pins, 3 each on two different levels past the taper. We rebuild them all. Bob@zpsusa.com
-
Member
Re: Journeyman 325 Tree Mill
Thank you we will check it out
-
Member
Re: Journeyman 325 Tree Mill
the was metal chips up inside the collet so we are hoping now its cleaned the tool will not pop out now
-
Member
Re: Journeyman 325 Tree Mill
Good luck. Shoot me an email if you need anything else!
Bob@zpsusa.com
- Need Help!- Journeyman 325 Tree Mill
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules