......
OK .... It would seem that nobody has had remove a X-axis Cross Slide table.
......
I do have a few more questions though ...........
1.) Does anybody have any current sources of where I might be able to purchase new brushes for the Baldor DC Servo Motor #CC22529?
2.) Can someone tell me what the length of a new carbon brush may be for this machine/servo motor?
My existing brushes are measuring about 0.412"
3.) Can someone point me to a source where I can purchase replacement brush caps?
While removing one of them I ended breaking it to pieces since it was so brittle. If I cannot find a source for these replacement caps, my next step will get getting them 3D printed.
Here is a picture of an existing brush I removed.
Here are some more pictures of the brushes and cap and there measurements .... LINK
Thanks .........
.....
.....
J325 Quick Links:
Machine
Existing Machine Schematics
Electronic Cabinet-Right Side
Electronic Cabinet-Back SIde
Existing Drive Board SD1525-10
J325 Servo Drive-SD1525 Manual
3-Phase Rotary Convert Used
RickB's J325 Retrofit Wiring
KFLOP 5VDC/15Watt/3A Power Supply
KANALOG Mounted & Connected
Kmotion - Axis Encoder Manual Test of Position via Manual Movement
Kanalog-Encoder Voltage High/Low Checks & 1KOhm Resister
Kmotion Configuration Screens "RUN-AWAY"
Tree Journeyman 325 Designed Specs.
Tree Journeyman 325 Axis-Tension Frequency Settings
Final Axis Tuned Error Parameters
VFD Wiring to Existing Tree325 Old Controller
DAC Values to RPM / Voltage Checks
Baldor DC Servo Motor Brushes and Cap
.....
.....