Sandvik 245 looks awesome but it was pricey Will def consider it! Now the new Fanuc OM-C controller prolly will arrive tomorrow so yesterday I made a scallop post of 500kB (25000 lines) that was supposed to machine in 1min 20sec. This is way more than the OMate control are capable of doing over DNC and most likely more than OM-C can do also. The purpose was to time the operation and observe the moves and to quantify the improvement. The Mate used 16 minutes to complete this job and it was stuttering as it moved due to beeing over the machines limit. It completed but if I milled in alu it wouldn't look great when it makes so many stuttering moves. Time will tell if the OM-C can improve this time and maybe even make it go kinda smooth. It's just a test anyways.. I won't be doing 3d surface work at 2500mm/min normally with it. Today I will pull the latest backups and remove the OMate control from my system making it ready to drop in OM-C when it arrives. I also tested rigid tapping. It works but the Fusion 360 post processor is throwing in a S500 M3 after the tool change. On rigid tapping it specifies in the manual that speed should only be commanded in M29 so I will have to figure out a way to rewrite post so it sets speed to zero. Since the S code is modal I assume it won't help that I just remove the S500 manually since speed is often commanded earlier on a job. Going to google it a bit later on.