...X files
Paper your plastic..rock the house
I don't want to muddy this thread any further and I'm done after this , but is the above not disagreeing , or the dump you took on cadcam and his teaching skills ?
you can make assumptions of another man's capabilities , except any assumption will probably be a fools assumption
Last edited by metalmayhem; 08-21-2021 at 10:42 PM.
...X files
Paper your plastic..rock the house
Last edited by machinehop5; 08-22-2021 at 12:30 AM. Reason: Y axis is start to be off center
Are no it is not disagreeing with anything, it's just a statement saying what happens when you use this method, which is known throughout the industry, this is not something I came up with or even care about
I do know one thing, that this method you use is primitive and in efficient for todays standards, For under $500 gets you a 3D probe that can work with any machine
Everything you have posted is not relevant to this thread, this is not about you and what you do or can do
The Op started this thread and wanted help with his probing and work setup, not about you what you do or your method
Mactec54
your nuts
good luck with your piece of plastic
Well this conversation continues to go forward. I am not worried about my methods of teaching or doing. I continue to help other's grow in there careers that make me feel good.
If I can help I will.
Mactec54 thank you for your opinion I think it has been well noted. I am sure we will see again here or at one of the shows again.
Quick not I will be closing this topic as it has gone it way.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Turning Product Specialist for a Software Company, contract Programming and Consultant , Cad-Cam Instructor of Mastercam .