The problem seems to be heat related, opened the electrical cabinet door for a few minutes and the problem went away, the program started fine.
I have a new error, never had it before, starting a program it will give a "probe jogging error during an MDI move" and shuts the program down. When I reset the program and restart it the same error happens. A reset and reload of the program fixed it for one run then it reappeared.
I did install a renishaw MI8 interface a few months back, I am wondering if that is causing the error??
any insight appreciated....... new one on me......
Similar Threads:
mike sr
The problem seems to be heat related, opened the electrical cabinet door for a few minutes and the problem went away, the program started fine.
mike sr
I believe the error is the result of a state change in the signal from the probe while moving. I suppose that could be a temperature related issue and the MI8 or perhaps vibrations are causing the contacts on your Renishaw probe to open for a fraction of a second.