Modifying Fusion360 post to set G64 value as parameter

Results 1 to 1 of 1

Thread: Modifying Fusion360 post to set G64 value as parameter

  1. #1
    Member
    Join Date
    Jun 2005
    Location
    USA
    Posts
    653
    Downloads
    0
    Uploads
    0

    Default Modifying Fusion360 post to set G64 value as parameter

    Here's the hack-job I did to my Tormach Fusion 360 post to support G64 values as a parameter. Hopefully this setting will get baked into a future factory post and maybe in a nicer manner. Use at your own risk, bla, bla....

    Edit the Tormach.cps file.

    At the end of 'User Defined Properties', immediately after the number in reversingHeadFeed and before the //, around line 64, add a comma.
    Insert a new line just after that one, before the } and make it look like this:

    Modifying Fusion360 post to set G64 value as parameter-capturetol1-png

    Drop down a few lines and add a description. Also add a comma at the end of the previous line

    Modifying Fusion360 post to set G64 value as parameter-capturetol2-jpg

    Search down for (64). Remove the gFormat.format(64) to make it look like so, adding the other highlighted lines.as well.

    Modifying Fusion360 post to set G64 value as parameter-capturetol3-jpg

    Save the post with a different name.

    When you go to post some code in F360, pick your newly saved post and you should have an setting called G64 Tolerance that you can change as desired.

    Modifying Fusion360 post to set G64 value as parameter-capturetol4-png

    Similar Threads:
    Last edited by shred; 06-20-2018 at 09:54 AM.


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Modifying Fusion360 post to set G64 value as parameter

Modifying Fusion360 post to set G64 value as parameter