Pathpilot corner probe

[sharmstr]

Exactly. Add buttons to find centre of hole, square boss and round boss and display the coordinates without changing anything.

I like the G54/G55/etc buttons! There isn't room for G59 P~ so perhaps spread the buttons a little although I worry about accidentally hitting Ref A.

While discussing a wish list for screen changes, I wish that the tool description were displayed somewhere. Perhaps below the M6G43/ Tool Length/ GO TO G30 buttons?

FYI - Tormach has 4 outer corner probing routines in the next version. I've added inner corner routines and handed the code over to them so hopefully it will be added after 2.0.2. (note: the code included the WCS buttons, so maybe they will see the benefit and add those as well).

@kstrauss - I'm also working on adding the finders you want. Here's the first one (2 videos), there will be more: https://www.instagram.com/p/BfWrWVpF...en-by=sharmstr

[ranchero60]

I know this is old but how did you add the g54 g55 g56 and so on? Thanks.

So similar to find x, y or z on the first tab? That's doable.

Up until this morning, I didnt know how to add buttons to PP. I've now figured it out and they actually work.

[cncoperator]

.

[sharmstr]

I know this is old but how did you add the g54 g55 g56 and so on? Thanks.

You need to modify the python and glade files. If you dont know how to do that, then I suggest putting in a feature request with Tormach.