Help plz ,my Accumove 3 THC can't start the job


Results 1 to 2 of 2

Thread: Help plz ,my Accumove 3 THC can't start the job

  1. #1
    Registered
    Join Date
    Aug 2016
    Location
    France
    Posts
    3
    Downloads
    0
    Uploads
    0

    Default Help plz ,my Accumove 3 THC can't start the job

    Hey ! i'm new here
    I have a Torchmate accumove 3
    When i run a job, the torch touch the material then go up ... and keep doing that without cutting
    I'm using Powermax 45
    Any one have an idea ?

    Similar Threads:


  2. #2
    Registered
    Join Date
    Aug 2011
    Location
    US
    Posts
    10
    Downloads
    0
    Uploads
    0

    Default Re: Help plz ,my Accumove 3 THC can't start the job

    If the torch makes contact with the plate and continues to slowly raise up, this means it is still detecting ohmic and trying to lift off the plate to break the circuit. Could be debri in the shield cap or you may have the shield cap screwed on too tightly, may try unscrewing the shield cap slightly to increase the clearance between the inner nozzle and shield cap.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Help plz ,my Accumove 3 THC can't start the job

Help plz ,my Accumove 3 THC can't start the job