Need help to identify plug on torch height control


Results 1 to 2 of 2

Thread: Need help to identify plug on torch height control

  1. #1
    Registered
    Join Date
    Apr 2017
    Location
    Gonzales
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Need help to identify plug on torch height control

    I have the Torchmate 3 torch height controller box and set up and the torch height doesn`t work properly.
    I bought this machine used and cannot get in touch with the previous owner to ask about the problem I'm having.
    I looked at the owners manual and the wiring is in place on the power supply. (Hypertherm Powermax 1650).
    I noticed a wire plug near the torch that is not connected to anything, just dangling there and I figure this might be the problem.
    I wanted to know if any of you might be able t help me here, thank you

    Similar Threads:
    Last edited by inspectweld; 12-26-2017 at 10:49 PM. Reason: Trying to add pictures


  2. #2
    Registered
    Join Date
    Apr 2017
    Location
    Gonzales
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Re: Need help to identify plug on torch height control

    Thanks anyway, I found out incidentally while searching the manual, it is a plug used for calibration by TM only and not used to actually run the machine and I did, for now anyway, solve the problem we were having with the AVTHC.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Need help to identify plug on torch height control

Need help to identify plug on torch height control

Need help to identify plug on torch height control