Router auto start


Results 1 to 3 of 3

Thread: Router auto start

  1. #1
    Registered
    Join Date
    Nov 2011
    Location
    United States
    Posts
    50
    Downloads
    0
    Uploads
    0

    Default Router auto start

    Nor sure this is the right forum group to put this in but I figured someone could help me out.

    I have a Torchmate CNC and I saw a picture of a little box a guy was using that would automatically turn the router on and off. all that had to be done was a simple line at the beginning and end of the G Code.

    Does anyone know where I can get one of these little modules ?

    Similar Threads:


  2. #2
    Registered
    Join Date
    Nov 2009
    Location
    USA
    Posts
    3
    Downloads
    0
    Uploads
    0

    Default

    You need a solid state relay. Wire the relay to your CNC breakout board and to your spindle also. Do a search for solid state relay.



  3. #3

    Default

    I don't think my g-code generates a line to enable my spindle. My mach3 enables it once the program starts up. I'm running RS232 to RS485 to the VFD. I think the Solid State Relay is the way to go on a router though



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Router auto start

Router auto start

Router auto start