Techno cnc Lathe - Page 3


Page 3 of 3 FirstFirst 123
Results 41 to 44 of 44

Thread: Techno cnc Lathe

  1. #41
    Member
    Join Date
    May 2008
    Location
    USA
    Posts
    84
    Downloads
    0
    Uploads
    0

    Default Re: Techno cnc Lathe

    Quote Originally Posted by johnohara View Post
    AR1911~

    Missed the "H" in the first part number. Apologies.
    KL23H2100-35-4B vs. KL23H2100-30-4B
    That will let you check the pdf file for each drive to compare specs.
    Aha! Thanks
    Quote Originally Posted by johnohara View Post
    The link I provided is an article that has a sub paragraph titled "Performance Factors."
    It does a nice job describing the "electrical time constant" of a stepper motor. Which
    is why those values are included in the motor's spec.

    ~john
    I bookmarked that to read this week, certainly looked useful.
    After reading through the G320X setup procedure, tuning those servos looks pretty fussy.



  2. #42
    Member
    Join Date
    May 2008
    Location
    USA
    Posts
    84
    Downloads
    0
    Uploads
    0

    Default Re: Techno cnc Lathe

    Quote Originally Posted by Pplug View Post
    Let us know how it turns out. I have read somewhere that the 1000 tick encoders have trouble with the gecko servo drives, but that was years ago. I read that the drivers couldn't keep up with the encoders. I read that 300 or 400 tick encoders work best. Just take my advice with a little salt. I'm not 100% sure. I hope it works for you.
    My success or failure may be no reflection on the hardware. I'm about as green as they come on this stuff.
    I'll be a bit more confidant once I get one of my machines running on Mach3 or EMC. I need that positive feedback.



  3. #43
    Member
    Join Date
    May 2008
    Location
    USA
    Posts
    84
    Downloads
    0
    Uploads
    0

    Default Re: Techno cnc Lathe

    I started a thread over in the Gecko support sub-forum. I can't match up the Servo wires to the drive connections.
    I may not have enough information on the servos to get there. We shall see.



  4. #44
    Member
    Join Date
    May 2008
    Location
    USA
    Posts
    84
    Downloads
    0
    Uploads
    0

    Default Re: Techno cnc Lathe

    I started a thread over in the Gecko support sub-forum. I can't match up the Servo wires to the drive connections.
    I may not have enough information on the servos to get there. We shall see.

    http://www.cnczone.com/forums/gecko-...ml#post1793842



Page 3 of 3 FirstFirst 123

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Techno cnc Lathe

Techno cnc Lathe