Need Help! Choosing a vice


Results 1 to 1 of 1

Thread: Choosing a vice

  1. #1
    Registered
    Join Date
    Jan 2016
    Posts
    8
    Downloads
    0
    Uploads
    0

    Default Choosing a vice

    Anyone tried this Shars 3x5 vice? The vertical dimensions are taig compatible (base clearsz rail, jaw clears z screw). Also curious if the LMC Z clamps would work on this vice (or is there some other off the shelf clamping solution)

    Other one I'm looking at is this LMC 3" Screwless (3" wide, 3.94" opening length, same listed squareness/hardness, but bigger overall in all dimensions). Given the larger overall dimension + smaller opening, it must be a beefier design? Will that result in better work-holding?

    I'm leaning toward the extra capacity unless there's a compelling reason to go the other way. It'd be a bit different if the LMC could handle 4" stock. Wonder if it would with a longer cap screw?

    Also, I'm mainly looking at vices that have the slots on the side, the hole just seem like extra work/complexity, unless I am missing something?

    Similar Threads:
    Last edited by averageJoe576; 03-26-2018 at 06:30 PM.


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Choosing a vice

Choosing a vice