Stepper Motor Driver Recommendation Needed

[3D_Router]

Hello I am working on a project where I need to have manual control over some motor directions/movements. Specifically, I need a pulse generator.

It needs to:

-Have a display to say its current rate/speed (this number can be arbitrary as long as the number always correlates with the output and is not random).

-Have PWM, DIR, and ENA signals.

-Output of these signals is 5-24 volts, 3.3v will not work. (Signals like the ENA and DIR signal).

-While not our exact motor model, these are the same type of the ones we use https://www.amazon.com/Davitu-Motor-...dp/B09FY67RF4/

Here is what we have tried and we cant use:

https://www.amazon.com/WSDMAVIS-Reve...dp/B08GP4NZJL/ Cheap feeling, screen flickers horribly not allowing you to see the number correctly. It works, but is way to low quality.

https://www.amazon.com/Controller-PE...dp/B0BK1GYBR1/ Would be perfect, but the output signals are 3.3v and does not work with our motors. The Enable signal works, but the PWM does not. We did confirm that this device works with a stepper motor driver and it ran a NEMA 23 perfectly.

https://www.amazon.com/15-160V-Adjus...dp/B07HNSVMVH/ No display, no housing.

Any helps at pointing me towards a decent PWM generator would be greatly appreciated.

Similar Threads:

• Stepper Motor and Driver Kit Reviews needed
• Stepper Motor and Driver Kit Reviews needed
• Stepper motor driver design, help needed with layout!
• Recommendation low voltage [12v] stepper driver??
• Recommendation for stepper motor and driver

[Jim Dawson]

Maybe this one? https://www.amazon.com/SainSmart-Ste...%2C143&sr=1-17

I have one of these that I bought for playing with. Mine seems to work OK, but the reviews indicate that some don't work out of the box. It's cheap, but a lot of functions.

If you want to go industrial quality, then Galil controllers are available on eBay. Maybe something like this. https://www.ebay.com/itm/39423997639...id=17026752801

Lots of control and display options with this, I normally hang a mini computer on these with a 10'' touch screen. You could hang a panel meter on it just to read pulse output. https://www.automationdirect.com/adc..._input#start=0

Or use one of the cheap Amazon pulse generators and just hang a panel meter on it.