Trying to get movement on my new Avid CNC machine but no dice.
I have to be missing something simple.
IDK if I need pull up resistors or if I need to do something to enable the drives.
1) I have checked the parallel communication showing 4.10v / 0v like it should be at each DIR Pin terminal block on the BOB output when I change key stroke/directions.
2) Motors are locking, all drivers are green.
3) Motor polarities are all correct.
4) Dip switches are set to 10micro and 3A, DIP/S #4 set to Half Current)
5) BOB Input voltage is 19v on 15-32v pin and 5v on 5v input pin.