Newbie Prolight 3000 turning center C-axis driver failure


Results 1 to 2 of 2

Thread: Prolight 3000 turning center C-axis driver failure

  1. #1
    Registered
    Join Date
    Sep 2011
    Location
    USA
    Posts
    12
    Downloads
    0
    Uploads
    0

    Default Prolight 3000 turning center C-axis driver failure

    I've encountered a problem with my Prolight 3000 turning center. I was learning how to use the machine by cutting a few tapered spacers when the machine buried the bit resulting in a stall. I cleared the machine and then the tool turret started acting erratically. It's very jerky as it rotates and it won't home correctly. I've been told by the factory that the driver is burned out and that they need to replace it. Is this something that I can fix by replacing a chip or is it much more complicated?
    Thanks.

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Prolight 3000 turning center C-axis driver failure-prolight-3000-pcb-jpg  


  2. #2
    Member chalio's Avatar
    Join Date
    Nov 2008
    Location
    usa
    Posts
    36
    Downloads
    0
    Uploads
    0

    Default Re: Prolight 3000 turning center C-axis driver failure

    i have the same problem with my turret after a crash, i took apart the turret and the bolt tat goes through the middle was loose, also it has a little flat bar that functions as a stop for tool position. i will say that is bend. you need to make it straight again.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Prolight 3000 turning center C-axis driver failure

Prolight 3000 turning center C-axis driver failure