There are new questions with using portable cutting machine.
(Q)How to check START Signal and if the wire or connectors are okay?
(A)
See if the cable is short even when CNC 2 cable is removed from the connector. If the cable is not showing shot when the CNC 2 cable is not connected to the CNC machine electrical box then do step 2.
(Q)How to check FINISH Signal and if the wire or connectors are okay?
(A)In the SteelTailor CNC cutting machine,Shot circuit finish 2 wires with a small wire.
Go to DIAGONOSE mode
When you shot circuit the 2 wires see if the state of the DLZ changes to 0 and when remove the short see if the state change back to 1
More information about SteelTailor FAQs, Pls visit:
Forum - Powered by Discuz!
Hope this is helpful to you .
Any other question ,pls email at service@steeltailor.com.
You can also find us easily on facebook:SteelTailor Twitter:SteelTailor,
Similar Threads:
- New Product- Year of portable Tube Cutting Machine Welcomes SteelTailor TubeTailor Cutting Machine
- Need Help!- How about SteelTailor portable cnc cutting machine? Which one is the best?
- Problem- How to change the cutting speed of SteelTailor portable CNC cutting machine
- SteelTailor portable CNC Cutting Machine
SteelTailor--The world leader of portable CNC cutting machine
www.steeltailor.com