Milling slots using rotary table


Results 1 to 1 of 1

Thread: Milling slots using rotary table

  1. #1
    Member
    Join Date
    Mar 2008
    Location
    USA
    Posts
    29
    Downloads
    0
    Uploads
    0

    Default Milling slots using rotary table

    Hello,

    Could someone check out the attached project file and let me know what I'm doing wrong. It does not seems right when running the simulation, like when it engage the end mill. Ignore the gouging as I want to be able to cut the slot to any width I want. Also for some reason with the default settings, it wouldn't rotate the part fully 360 degree so I had to use "Exit overlap" under Overlaps to make it cut all around.

    Is there a better way of doing this? I tried Rotary machining, but couldn't get it to work. There is an option called Cylinder radius under Transformation... any idea what it does? Lastly, any suggestions for feed rate and step down? I'm using 2flute end mill and not 4 like it says. Running Sprutcam 11.5.

    Thank you

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Milling slots using rotary table-jacketv3-50-75mm-rotary-jpg  
    Attached Files Attached Files


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Milling slots using rotary table

Milling slots using rotary table