During warm up, the spindle does not sound right at the highest RPM (24000). I thought the sounds was a much higher squeal pitch, whereas now it is much deeper and louder – as in it made me rush to see if everything was ok. Perhaps it is just me, but I wanted to get your thoughts. I recorded video of it and uploaded to my YouTube channel – the issue occurs right after the 3:53 point.
Similar Threads:
Only 2 months old with just a few hours on it. I will have to see what Camaster support wants to do. I had some stuff I wanted to do over the weekend - not sure if I should....
Mactec54
Turns out it was a particular 3/8" bit that was causing it. New bit with only a few cuts on it, but who knows. I ordered another to see if it changes things.