Ae-200 vfd problem mach3 rpm doesn't match with vfd

[Chmfhm]

My vfd is Ae-200 it runs on 12v. I plugged it on 10v and run and trying to do some setting. After that I plug it back to 12v factory setting. After that my vfd rpm doesn't match with mach3. I am sending pictures of mach3 vfd and also manual of vfd.

Any help will be highly appreciated

Similar Threads:

• Need Help!- VFD Configuration With Huanyang VFD [ Model: HY02D223B ], C10, C6, Mach3
• Need Help!- vfd mach3 problem
• Can't control VFD RPM, with Mach3
• Axis travel (physically measured) doesn't match Mach3
• Need Help!- Need to match VFD to HSD Spindle?

[mactec54]

My vfd is Ae-200 it runs on 12v. I plugged it on 10v and run and trying to do some setting. After that I plug it back to 12v factory setting. After that my vfd rpm doesn't match with mach3. I am sending pictures of mach3 vfd and also manual of vfd.

Any help will be highly appreciated

If your Breakout Board requires 12v that would be normal, the PWM to Analog spindle speed control can only be 0-10v