Spindle & VFD Confusion

[markenfield]

Hi all,

At the moment I am as green as grass, lol

I have just purchased the following spindle and VFD INVERTER Huanyang Brand 2.2KW

2.2kw spindle motor
Frequency: 400 Hz
Voltage: 220V~250V Power: 2.2 KW
UPC: 283961306057 Speed: 8000-24000 R/min
EAN: 0283961306057

I am based in Melbourne Australia. Is there anyone out there from Aus? Has anyone set up this configuration before?

Not been getting much help from the eBay seller. The spindle I am confident but the VFD Inverter I am a little confused as to the power etc.

I have told them that the required unit is to be 2.2KW 380V ???

Similar Threads:

• mazak sub spindle turning confusion
• Need Help!- Spindle as stepper setup confusion
• VFD size confusion for a 4kw spindle, 220v single phase input
• Confusion with R8 Spindle and Collets
• X2 spindle dimension confusion

[mactec54]

Hi all,

At the moment I am as green as grass, lol

I have just purchased the following spindle and VFD INVERTER Huanyang Brand 2.2KW

2.2kw spindle motor
Frequency: 400 Hz
Voltage: 220V~250V Power: 2.2 KW
UPC: 283961306057 Speed: 8000-24000 R/min
EAN: 0283961306057

I am based in Melbourne Australia. Is there anyone out there from Aus? Has anyone set up this configuration before?

Not been getting much help from the eBay seller. The spindle I am confident but the VFD Inverter I am a little confused as to the power etc.

I have told them that the required unit is to be 2.2KW 380V ???

The VFD drive, you have will run on your 230v/240v Single phase but if you have 400v / 415v 3phase then yes you would want there 380v VFD Drive and spindle both the VFD Drive and the spindle need to be the for the same voltage that you are going / want to use