Huanyang Inverter + Next Wave Automation CNC

[madmaxh3]

O.k., I've got a 2.2 Kw inverter and a Piranha XL controller, is there any way to enable spindle on/off ?
I am not afraid to open the case of the controller, nor am I afraid to do some soldering, if I have to.
Any help would be GREATLY appreciated.

Similar Threads:

• Need Help!- huanyang inverter HY020223B 3hp 2.2kw
• Need Help!- 220V in to Huanyang Inverter
• huanyang inverter burn
• Need Help!- Huanyang inverter

[mactec54]

O.k., I've got a 2.2 Kw inverter and a Piranha XL controller, is there any way to enable spindle on/off ?
I am not afraid to open the case of the controller, nor am I afraid to do some soldering, if I have to.
Any help would be GREATLY appreciated.

After looking up what you have contact the manufacture

[madmaxh3]

mactec54,

I believe I know the correct parameters for the VFD. Attached are three photos of the BOB (not pro quality, sorry).

[mactec54]

mactec54,

I believe I know the correct parameters for the VFD. Attached are three photos of the BOB (not pro quality, sorry).

The next wave I believe is a bad idea, you need a Relay to switch FOR and DCM on the VFD Drive if the Next wave has a spare output that could turn a Relay On /Off that is all you need I don't see a Relay on there Board

It's just a switch with no voltage on the Relay output

[madmaxh3]

Thanks mactec54,
I think I have a relay that will work, I'll check it out.