Originally Posted by
Bill_B
Hi All,
WOW looking threw the forums offered here what I great resource! Hopefully, Im posting in the correct forum.
New here, I am installing a Huanyang VFD Inverter and Chinese Amazon spindle kit on our Zenbot CNC router. The VFD is under power and spindle is running but will only run at about 150 RPMS when I turn the potentiometer. After wiring it up I "tried" to go through the initial set up steps to get the VFD programmed properly but not sure it is right. I did it a few times but Im not sure how to confirm the setting are correct? How do I confirm this?
Is there anyone here who can help to get this spindle set up and running, set up with Mach3 controller, be able to program my spindle speeds in my CAM. I also have a cheap China Z probe I need to set up with my controller or Mach3 not sure how it gets wired in and If it Z 0s itself when it hits the prob disk. I would also like to have the ability to tun on Vacumme on program start from my CAM if possible.
Lots of Youtube vids but I do not find my exact model and some of the conversations in vids are beyond my electrical knowledge which is limited.
The model we have is the 110V ER 11 kit VFD Model number is HY01D511B.