PD001 = 1 External terminal.
Also close the FWD or REV PLC input.
Al.
Hello!
I have a Huanyang HY01D523B, with a 1,5kw spindle.
Im trying to set up the inververter that I can control the rpm from my CNC program Estlcam.
I´ve been searching everywhere for info but I cant find any.
I have connected everything as I think it should be: ACM (from inverter) to GND on controller card (Estlcam interface), and VI (from inverter) to 0-10v on the controller card.
But what settings do I need to do on the inverter, to make it all work?
See pics of interface and inverter terminal
/Ola
Sweden
Similar Threads:
- Need Help!- 220V in to Huanyang Inverter
- Huanyang inverter PD settings
- Need Help!- Huanyang inverter
PD001 = 1 External terminal.
Also close the FWD or REV PLC input.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
The VFD has 6 multi function inputs operated by a contact closure to DCM (COM) they come with default settings but can be changed for up to 32 option settings.
The default FWD/FOR is enable forward run mode.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Contact closure means close the circuit - switch on - connect together etc.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Because you have to use a Switch or controlled Relay where the Jumper you added between the For and DCM
What is the other white wire doing it should not be there in For
So if you cut the Jumper Wire and put a Switch in the middle that will turn it On / Off if you have the parameters set correct
Mactec54
Ok. Done. See pic.
DCM & FOR connected to relay on controller card.
ACM & VI connected to GND & 0-10v to controller card interface.
With connections, the spindle on/off is working. But not the rpm control.
I tried all different parameter settings on pd001 and pd002.
So what am I doing wrong here?
Try it purely manual, with a switch or link between DCM and FOR connect a 10k pot across VR, V1 (slider) & ACM.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Just got an email from Estlcam. He said the same thing. He also said, make sure you have 12v power supply to the interface card. I didn’t know about that. Estlcam don’t have any manuals or what so ever.
Of course he didn’t write how to connect the power in the terminal.
Guess I have to wait for another couple of days before he replies on that quest.
Do you have any idea of how to connect the 12v? See pic.
The terminal strip pic does certainly does not indicate anything definitive.
Why is there zero support on the product?
I would be very reluctant to obtain anything with no manual or supports etc?
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Is it working? Rpm over estlcam?
I think it is digital pin 5 on arduino.