Where are the red, black and blue wires on the VFD going to? I can't see what terminals those are, the wires are in the way.
Hello
I would like someone to look at the attached pictures and tell me what I am doing wrong. I am using a control board from Automotion Techologies and need to wiring up my VFD to it.. And it seems pretty cut and dry but NOT. I wiring the VFD 220V and the spindle is wired to the VFD but the control side of the board to the VFD is not..
I have emailed Automotion Tech and nothing back..
Similar Threads:
Where are the red, black and blue wires on the VFD going to? I can't see what terminals those are, the wires are in the way.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
The Red wire is X1, Black is X2 and Blue is AI
[QUOTE=FishRiver;2138566]My next question is on the board.. (See PHOTO)
The PWM(P1) and the 10 volt connects where on the VFD.
I am sorry if I am asking these questions but I want to be sure..
Looking at this again
The Breakout board has PWM P1 where does that connect to..
Also 10 v connects to AI and GND is this a jumper between AI and GND
- - - Updated - - -
[QUOTE=FishRiver;2138566]My next question is on the board.. (See PHOTO)
The PWM(P1) and the 10 volt connects where on the VFD.
I am sorry if I am asking these questions but I want to be sure..
Looking at this again
The Breakout board has PWM P1 where does that connect to..
Also 10 v connects to AI and GND is this a jumper between AI and GND
Looking at this again
The Breakout board has PWM P1 where does that connect to..
Also 10 v connects to AI and GND is this a jumper between AI and GND