A bearing puller won't pull it off?
I have my perske spindle stripped down for a bearing change and the only way I can see to get to the lower bearing is to press the rotor off the shaft. I paid to have the bearings changed 2 years ago and I can see an alignment mark engraved into the shaft and rotor, which also leads me to believe this is the correct course of action. Anyone have experience with this? How hot should I heat the rotor before I attempt to press it off? Thanks for any input.
Similar Threads:
A bearing puller won't pull it off?
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
The bearing I need to change is in the black housing on the collet end. The bearing you can see on the other end isn't an issue.
Thanks for your input