Solidcam G code ERROR line 3708

[persecan]

Hello
this error occurs when I want to generate the g code
can you help me ?

Similar Threads:

• Solidcam Error - Can't uncompress CAM-part. Check SolidCAM temporary folder
• Need Help!- SolidCAM line, arc, rapid G-code in every line
• Need Help!- SolidCam Postprocessor with g in every line
• Need Help!- How to make Mach3 go line by line in the g-code?
• Need Help!- way to see the g code comands visualized line by line in Bobcad?

[Danpil]

You need to see line 3708.

[persecan]

you can give me more details ?

[steryd]

In sufficient GPP file is a problem with this line. Maybe just needs to be disabled if the G code looks fine though the error occures.

[persecan]

g code is not generated
Can I be more specific on how to fix this problem?

[steryd]

Gcode is not generated if u press cancel. If u press ok when the error occures it will be generated anyway. With or without wrong lines.

Anywhay can U show what line 3708 in MT_Nakamura_NTRX300L_Fanuc31i_XZYCB_BS.gpp looks like?

[persecan]

line 3708 does not exist in the gpp file

[steryd]

Lines are not numbered. U need to look at status bar in notepad.

[persecan]

I found the line

see the picture below

[steryd]

Try putting ; in front of this line. Looks like problem with procedure get_tool_dir_in_station. Maybe it isn't defined, or missing variables.
Quite probably it won't harm g-code, or maybe not in every case.

[persecan]

thx

I managed to put ";"

now the error below appears see the pictures