Slowing down the final few cm of a cut in solidcam

[Stephanisk]

Hi you all,


I have something I would really like to implement but I do not find the setting in solidcam that would do what I want.

Let me explain. When cutting wood materials and doing a deep cut like 18mm full slot 4F endmill depth of cut 18mm. Cutting the wood works just fine but as there are heavy forces at work on my vacuum table I would like to slow down the feed for the last 50-60mm as when the parts become smaller they tend to pop off the vacuum because of the high federate (4000mm/m).

Is there any way to program this or set in solidcam to slow down the feed rate in the end to 10% of the normal federate. I have seen that you can set lead in lead out as a percentage of feed and speed. But that is set to the real lead out and doesn't effect the actual speed of the cut feed rate

Thanks.

Similar Threads:

• HELP - Slowing down the Traverse
• slowing jog?
• Slowing a spindle down
• Slowing down of potentiometer
• Slowing a motor

[Stephanisk]

Anyone any idea?

[kla2]

You can "end" usual run and start lead out before real end of pass according "Geometry". @"Technology"-"Geometry" you can vary end of every curve.