Greetings from India.
Am trying out a CAM program for one of the component in SolidCAM 2018 trial version.
There is one roughing (HSR) and one finishing (HSM) program for the component. The simulation does work good.
When the GCode is generated we find that the postprocessor does have in one of the block as J0. K2 and this is creating an error on the VMC and we are unable to proceed.
can anyone help me in this?
Regards.
Turn off the SolidCAM and go to solidcam postprocessor path, next you need open your machine file with *.vmid extension. Then on second tab (controller definition) open section named Arc Execution Definition and check U have Arcs in ZX/YZ Plane set to NO.