Need Help! syntec 900M controller


Results 1 to 3 of 3

Thread: syntec 900M controller

  1. #1
    Registered
    Join Date
    May 2018
    Location
    Lebanon
    Posts
    6
    Downloads
    1
    Uploads
    0

    Default syntec 900M controller

    anyone know the M code for air blow in syntec??
    M8 for coolant
    M7 for collant through spindle

    Similar Threads:


  2. #2
    Registered
    Join Date
    Jan 2012
    Location
    USA
    Posts
    36
    Downloads
    0
    Uploads
    0

    Default Re: syntec 900M controller

    Hi ali789,

    Don't quote me on this but I believe machine builders can assign them, sometimes even during setup of the machine. I would think they have a specific one they like to use but it could be a different M code on two of the same machines. It would probably be best to call the machine manufacturer. There does seem to be a lot of post guys reading these threads so they may have your answer off the top of their heads or at least can give you a couple to try. I'll keep checking.

    Darrin - SolidCAM



  3. #3
    Member
    Join Date
    Jan 2018
    Location
    United States
    Posts
    38
    Downloads
    0
    Uploads
    0

    Default Re: syntec 900M controller

    That information is correct. The machine builder / end user can customize the M-codes to their preference. Usually builders will follow Fanuc standards, but it is not always the case. If you can find what Output relay is controlling the air blow you can find it by looking at the ladder of the control.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

syntec 900M controller

syntec 900M controller