can't change spindle direction?

[cryptopsy]

In solidcam 2017, using the fanuc 2013 turning post, in this facing operation (see screenshot), changing from CW to CCW both generate M3 spindle start codes (not M4, as i was expecting). Am I not understanding how to change spindle direction?

Similar Threads:

• Need Help!- 2D profiling - change cut direction? v26
• Spindle enable only cycled AFTER direction change
• Need Help!- How to change the direction of cut
• Change X Direction on SL-5
• How do I change the direction of cut?

[Mikay19]

Hi cryptopsy,

Sounds like the post has been hard coded. I would check with the person you gave you the post.

Darrin - SolidCAM USA