had to upgrade to the SS on an older router machine after my last computer with a parallel port finally died.
Can't seem to get any movement out of the machine in spite of double checking connections.
I can't seem to find any GOOD documentation on the ethernet board, the BOB C25 or the software interface.
Anybody find any basic into on this? It's been so long it's like I'm starting from scratch with my first CNC. UG!!!
Similar Threads:
Is a sentance fragment?
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)