ESS upgrade problem


Results 1 to 2 of 2

Thread: ESS upgrade problem

  1. #1

    Default ESS upgrade problem

    Upgrading an older machine from parallel port to ethernet SS. Got everything hooked up and so far as I know the 'puter is talking to the SS board. I can toggle the e stop led on and off in mach (3).

    Not getting any movement out of any of the axis.

    DRO in mach will go up and down as commanded by keyboard but no movement at the steppers.

    The led lights next to the pins on the SS do not change state while attempting to move and of the axis.

    The leds on the SS all come on when powering up the SS without connected to mach. Once Mach is running they go out.

    Any ideas?

    Thanks!

    Similar Threads:
    Is a sentance fragment?


  2. #2
    Member Bluesux01's Avatar
    Join Date
    May 2019
    Posts
    6
    Downloads
    0
    Uploads
    0

    Default Re: ESS upgrade problem

    Is the IP address correct? That would be the first thing to check.


    Sent from my iPhone using Tapatalk



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

ESS upgrade problem

ESS upgrade problem