- ftl320 turret advancing multiple tools per "tool-change" button
-
Member
ftl320 turret advancing multiple tools per "tool-change" button
Hi guys, just got my lathe powered on for the first time.
About to start putting tools in the changer, while cleaning out the cosmoline grease I hit the tool-change button on the interface. Instead of incrementing 1 tool, it rotated through 7 positions.
Got me from T1 to T2, but it went T1 > T8 > T7 ... > T2. While its correct, it seems very slow and likely a problem that could cause a ton more wear and tear on the tool changer than needs to happen.
I looked in the system menu, saw a few settings dealing with Turret, but nothing even closely intuitive or directly pertaining to my issue.
Anyone else have this happen? If so, any recommendations on how to fix it?
Similar Threads:
-
-
Member
Re: ftl320 turret advancing multiple tools per "tool-change" button
Replying to myself in case someone else hits this in the future:
I emailed Kade, apparently my tool changer was spinning backwards because input power phase was incorrect.
After reversing 2 wires in the input power wires my tool changer is back to normal and advances only 1 step in the correct direction.
- ftl320 turret advancing multiple tools per "tool-change" button
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules