Can´t Reload the NC Start up screen 2 seconds than chat down

[Fire_in_the_hole]

Hi,
This applies to the system GA3 on Siemens Sinumerik 810M

I have restarted my Siemens Sinumerik 810M many times after the batteries have run out due to inactivity in this machine but most recently I do not manage to get the actual uppstart system.

Note that the problem is not uploading TA1,TA2 which is a natural consequence of processor booting.
The LED on the component board (X111 to the right) is lighting red, I think this tell us the processor 50Mhz was not boot up.
Any how now more why.

I press and hold the Eye button and start up with the NC button and the screen lights up for at most 2 seconds. Everything looks great on the screen. Also a red LED above the screen that says the system is not ready because no parameters are loaded.
Any how have seen this before.

Attachment 488909

[mlinkadelsol]

Hi,
This applies to the system GA3 on Siemens Sinumerik 810M

I have restarted my Siemens Sinumerik 810M many times after the batteries have run out due to inactivity in this machine but most recently I do not manage to get the actual uppstart system.

Note that the problem is not uploading TA1,TA2 which is a natural consequence of processor booting.
The LED on the component board (X111 to the right) is lighting red, I think this tell us the processor 50Mhz was not boot up.
Any how now more why.

I press and hold the Eye button and start up with the NC button and the screen lights up for at most 2 seconds. Everything looks great on the screen. Also a red LED above the screen that says the system is not ready because no parameters are loaded.
Any how have seen this before.

Attachment 488909

Hy, I think my machine does the same. RED LED light is on, machine is stuck on initializing screen. "Eyeball" button doesnt work so I cant upload parameters.
Did you figure out what the problem was?
Thank you.