Need Help! Z SHIFT ERROR

Results 1 to 1 of 1

Thread: Z SHIFT ERROR

  1. #1
    Registered
    Join Date
    Feb 2018
    Location
    United States
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Z SHIFT ERROR

    When setting the Z on a Thermwood CS-45-510 we usually type on the keybaord (TML) (due to the automatic bit setter does not work) never has since ive started) Then do our normal numbers we put in to figure out the daylight....save the number usually around 8.100. Go to run a program (usually test run it) and when its going to start the routing program. The bit is about a 1/4" up. Even after setting the daylight! Any suggestions!?!?!?

    Similar Threads:
    Last edited by Rhoover6; 02-13-2018 at 08:21 PM.


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Z SHIFT ERROR

Z SHIFT ERROR