Sinumerik 3M

Results 1 to 2 of 2

Thread: Sinumerik 3M

  1. #1
    Registered NC-Technik's Avatar
    Join Date
    Dec 2008
    Location
    Altdorf
    Posts
    20
    Downloads
    0
    Uploads
    0

    Default

    Hello
    I do not know if I'm right here now, but whatever.

    On my screen "PC error" is displayed and nothing else (on a System 3 controller)

    The machine was running previously and the back-up battery was replaced about 2 months ago. After switching it on/off, nothing came up anymore. On the NC-PLC coupling, the left LED flashes (how many Hz? No idea). After a couple of times turning it on and off again, it worked for about 5-10 minutes and then the same image came up again. Since this morning, nothing works anymore. Does anyone know that problem and / or has a solution? We will still check the 24V supply and the battery but I do not think that is where the error lies. So please say your opinions and hunches whether they are meaningful or not, I will try everything.... wink.gif

    Best regards
    volker



  2. #2
    Aslan's Avatar
    Join Date
    May 2007
    Location
    Nevsehir
    Posts
    69
    Downloads
    0
    Uploads
    0

    Default

    Did you already achieved something?
    Best regards
    Aslan

    Nichts ist unwichtig...


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Sinumerik 3M

Sinumerik 3M