2041 program not in the memory

[audi27404]

Hello
I’ve got a problem with our CNC turning machine Niles N10. The CNC reports the following error: 2041 program is not in the memory. What should I do?

[InTex]

Hello
I’ve got a problem with our CNC turning machine Niles N10. The CNC reports the following error: 2041 program is not in the memory. What should I do?

Hello

Very easy: just load the program to the memory.

You also should clarify why the error occurs.

Maybe your main program can’t find a subprogram because there isn’t any.

Or maybe there’s a main program but it hasn’t been loaded yet.

[audi27404]

Thanks for the rapid answer.
How is the program loaded to the memory?

[InTex]

Hello

How is your program made? Is it just a main program?

In this case, it works as follows:

Automatic mode

Input program number, for example %111

Program start
If there’s a subprogram, you just should have it in the memory.

If it can’t be found, it’s not in the memory or it has u number that differs from the number the main programs searches for.