Help problem with lathe threading. Siemens 808d turning

Results 1 to 2 of 2

Thread: Help problem with lathe threading. Siemens 808d turning

  1. #1
    Activation process Industool's Avatar
    Join Date
    Sep 2018
    Posts
    4
    Downloads
    0
    Uploads
    0

    Default Help problem with lathe threading. Siemens 808d turning

    I have owned this lathe for just over a year, and was trying to find a good PP for it. All was fine until I came to the threading cycle. I just could not get it to thread. So I went to the controller (Siemens 808d) and entered the Cycle 99 and then ran it. At 10 RPMs I could the threading tool would go to correct threading depth then rapid to the end of the cut and start the cycle again. I am new at CNC so I don't have a lot to draw on. I was threading with it about 2 month ago and it was fine. I even took the same post and ran it again and got the same results. Have any ideas?

    Similar Threads:


  2. #2
    Member
    Join Date
    Feb 2011
    Location
    usa
    Posts
    353
    Downloads
    2
    Uploads
    0

    Default Re: Help problem with lathe threading. Siemens 808d turning

    can you post the program for the threading cycle



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Help problem with lathe threading.  Siemens 808d turning

Help problem with lathe threading.  Siemens 808d turning