Hello and good morning
The R-parameters aren’t enabled under ShopTurn. Only in the pure ShopTurn/ DIN ISO.
Greetings
Hello fans, freaks and those who know everything about ShopTurn!
Unfortunately, I know that input masks don’t accept any R-parameters. But how is it possible to use the data programmed in separate work steps (like diameter, length, angle, X1 X0 etc.) in a DIN-line? Where are they stored?
Greetings from mountains and thanks in advance
Franz
Hello and good morning
The R-parameters aren’t enabled under ShopTurn. Only in the pure ShopTurn/ DIN ISO.
Greetings
HelloHello and good morning
The R-parameters aren’t enabled under ShopTurn. Only in the pure ShopTurn/ DIN ISO.
Greetings
Here is an example for editing with R parameters
Regards, Fred