Parameters of ShopTurn

Results 1 to 3 of 3

Thread: Parameters of ShopTurn

  1. #1
    Registered reitstock's Avatar
    Join Date
    Dec 2006
    Location
    Allg
    Posts
    83
    Downloads
    0
    Uploads
    0

    Default

    Hello fans, freaks and those who know everything about ShopTurn!

    Unfortunately, I know that input masks don’t accept any R-parameters. But how is it possible to use the data programmed in separate work steps (like diameter, length, angle, X1 X0 etc.) in a DIN-line? Where are they stored?

    Greetings from mountains and thanks in advance
    Franz



  2. #2
    Karlsson
    Guest

    Default

    Hello and good morning

    The R-parameters aren’t enabled under ShopTurn. Only in the pure ShopTurn/ DIN ISO.

    Greetings



  3. #3
    blokzijf's Avatar
    Join Date
    May 2007
    Location
    Amersfoort
    Posts
    374
    Downloads
    0
    Uploads
    0

    Default

    Hello and good morning

    The R-parameters aren’t enabled under ShopTurn. Only in the pure ShopTurn/ DIN ISO.

    Greetings
    Hello

    Here is an example for editing with R parameters

    Regards, Fred



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Parameters of ShopTurn

Parameters of ShopTurn