Cycle face milling is on strike!

Results 1 to 2 of 2

Thread: Cycle face milling is on strike!

  1. #1
    Registered simonugarfunkel's Avatar
    Join Date
    Jun 2007
    Location
    V?hrenbach
    Posts
    32
    Downloads
    0
    Uploads
    0

    Default

    Hello everybody!

    The cycle face milling doesn’t work at my ShopMill.
    I supposed my own disability but even when I write an original example of a program from the manual guide, the following error occurs:

    “14001 channel 1 line unacceptable line end ”

    What am I doing wrong?

    Greetings



  2. #2
    Drehpapst's Avatar
    Join Date
    Apr 2005
    Location
    Hemmingen
    Posts
    652
    Downloads
    0
    Uploads
    0

    Default

    There’s an unacceptable end of a line, as the error already says.
    Show us your program 1:1, then it’ll be sure possible to help you.

    Gruß,<br /><br />Drehpapst<br /><br /><br />Willen braucht man. Und Zigaretten.<br />Wer Visionen hat, sollte zum Arzt gehen.<br />Helmut Schmidt


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Cycle face milling is on strike&#33;

Cycle face milling is on strike&#33;