Need Help! Lorenz Gera Hobbing L5-150 retrofitted with Siemens PLC contol

Results 1 to 1 of 1

Thread: Lorenz Gera Hobbing L5-150 retrofitted with Siemens PLC contol

  1. #1
    Member Sundaraj51's Avatar
    Join Date
    May 2020
    Posts
    2
    Downloads
    0
    Uploads
    0

    Post Lorenz Gera Hobbing L5-150 retrofitted with Siemens PLC contol

    I need help , my Lorenz gear hobbing machine retrofitted with Siemens PLC based control, The hob spindle and work table run with single motor, during cutting gear with module 2.5 both the hobbing spindle and table stops, after few seconds starts again, during this time motor does not trip due to overload. can any gear expert guide any mechanical check points electrically checked by siemens engineer no problem, unfortunately I do not have any manuals regarding mechanical assembly, also machine specifications .
    can somebody help me and guide.

    Similar Threads:
    Last edited by Sundaraj51; 06-12-2020 at 10:47 AM. Reason: Spelling Mistake


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Lorenz Gera Hobbing  L5-150 retrofitted with Siemens PLC contol

Lorenz Gera Hobbing  L5-150 retrofitted with Siemens PLC contol