- programming Siemens controller
-
Registered
Hello
I am not sure if I am in the right forum but can anybody tell me if all Siemens controller use the same programming?
So can I use a program that was written for a 840D, on a 802S controller?
Or are there different cycle?
Many thanks in advance!
Kind regards
Dominik
-
-
Hello
As long as your write your programs in DIN then the programs are interchangeable. However every manufacturer has its own preferences regarding H-words and M-command. However that can be change easily.
But you can forget the cycle, they are too different, It’s better to re-defined the cycle again on the particular machine. Of course that also includes the cycle call. You will find the necessary information on Doconweb and Sinupedia
.
Regards
Michael
- programming Siemens controller
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules