Hello falcon_x
I think that you can solve it with a timer ($AC_TIMER) and then read it out with a R-parameter that is not used yet.
E.g.
$AC_TIMER[1]=0
PROTON
...
...
...
PROTOFF
STOPRE
$AC_TIMER[1]=-1
R3=$AC_TIMER[1]=-1
Regards
Hello colleagues
Can anybody tell me where the milling time (start with PROTON, End with PROTOFF) is saved on a 840D and how I can read it out?
Kind regards
Joe
Hello falcon_x
I think that you can solve it with a timer ($AC_TIMER) and then read it out with a R-parameter that is not used yet.
E.g.
$AC_TIMER[1]=0
PROTON
...
...
...
PROTOFF
STOPRE
$AC_TIMER[1]=-1
R3=$AC_TIMER[1]=-1
Regards
Hello Thilda
Thank you very much for your quick help!
Regards
Joe
I have tested several alternatives in Sinutrain. However without PROTON/PROTOFF.
However the error message unauthorized"Array-Index1" comes up continuously.
Either the software cannot cope with it and I have to check it on the machine.
Or do I have to activate anything?
I can’t find anything in the documents...
Eine Schraube ohne Gewinde ist ein Nagel<br /><br />Grüsse aus dem Harz - InTex<br />
Hello
I think there is a mistake
try
R3=$AC_TIMER[1]
Instead off
R3=$AC_TIMER[1]=-1
Now the time (in seconds) should get displayed in R3