Hello butscheronieUnfortunately I’m not really fit in free contour programming.
Could anybody tell me how it’s possible to program a straight line under an angle with a defined length of 72,8mm (see picture)?
I think I should begin as follows:
G1 ANG=15,95…………. And then?
You also need a measurement at the end point (X or Y).
Maybe you should make it with polar coordinates…
G1 X0 Y0
G111 X0 Y0 ; declare Pol (absolute)
G1 AP=15.95 RP=72.8 ; rack in line with angle 15.95 and length 72.8
I hope it’ll help
Regards, dekoboy