Hello as far as I know it should look like this:
N26 TRAORI
N27 G0 B0 C=DC(0)
In the second case I would say - G53 and SUPA are identical, that’s why the multiple programming occurred.
Hello everyone
From the PP run get the following error messages. Can anybody tell me what I am doing wrong? Machine is a DMU 50eco Siemens 840D.
KANAL 1 block N27 orientation transformation not available -----------------------------------
program extract
N14 ROT
N15 TRAFOOF
N18 T20
N19 M6
N20 S2000 M3
N22 R98 = 300 ; IMMERSION FEED
N23 R99 = 1000 ; MILLING FEED
N24 CYCLE832(0.03,3)
N25 TRANS
N26 G0 B0 C=DC(0)
N27 TRAORI
N28 G54 D1
N29 AROT X0 Y0 Z0
and these messages:
KANAL 1 block N20324 same G-group program several times
program extract
N20323 M9
N20324 SUPA G0 G53 D0 Z0
N20325 SUPA G0 G53 D0 X0 Y0 (G53 twice ???)
N20326 TRAFOOF
N20327 G0 B45 C=DC(270)
N20328 TRANS
N20329 ROT
N20330 TRAORI
N20331 G54 D1
N20332 TRANS X0 Y-20 Z0
N20333 AROT X45 Y0 Z0
N20334 X34 Y-23.971
Thank you a lot
Have a nice Easter time!!
Matthias
Hello as far as I know it should look like this:
N26 TRAORI
N27 G0 B0 C=DC(0)
In the second case I would say - G53 and SUPA are identical, that’s why the multiple programming occurred.
Eine Schraube ohne Gewinde ist ein Nagel<br /><br />Grüsse aus dem Harz - InTex<br />
Hello ANI-MAT
G53 and SUPA are not modal as far as I know, that why the command has to be in every single row./G53 twice???)
Regards woaldy
TRAORI is not unlocked-it seems like the license is missingN27 TRAORI
KANAL 1 block N27 orientation transformation not available
SUPA and G54 affect the individual block and have a similar affect. G53 suppress all transformation in the programmed block above G500.N20324 SUPA G0 G53 D0 Z0
KANAL 1 block N20324 same G-group programmed several times
SUPA reduces all transformations in the programmed block to the MKS (also G500 is suppressed)
Hence both command are not allowed to be used together.
As you have the error number you can have a read in the Diagnostic Manual.