- incremental neutral point shift
-
Hello everybody
I want to move the NP always around the same value.
It should like similar to this:
MPF.1234
T1L6 (miller d5)
G54 S5000 F1000 M3
G0 Z100 M8
G59 X0 Y0
L100 P10 (UPG. 100. 10 x repeat)
G59 X0 Y0
M30
SPF.100 (CONTOUR pocket)
G0 X0 Y0
G0 Z-2
G1 G41 Y10
G1 X-10
G1 Y-10
G1 X10
G1 Y10
G1 X0
G1 G40 X0 Y0
G0 Z50
G59 X30 Y0 ( the NP is always move around 30mm,so the subprogram is carried out 10 times at the same position.
M17
Is it possible to move the No incremental? So that the program at the top would work?
I couldn’t find anything in the manual
Regards
Schura.
-
-
Registered
Hello
Write the neutral point shift into the sub program.
G90-Absolute dimensioning
G91-incremental dimensioning
%SPF1
G91
G59 X30
G90
.
.
.
.
G59 X0
M17
Regards
Matthias
- incremental neutral point shift
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules